Rolling mill

Detailed consultation with customer service

cold rolling

Cold rolling: the hot rolled steel coil is used as raw material, and the oxide skin is removed by pickling. The finished product is hard rolled coil. The cold work hardening caused by continuous cold deformation makes the strength, hardness and toughness plastic index of hard rolled coil increase, so the stamping performance will deteriorate, and it can only be used for simple deformed parts. Because of its high hardness (HRB greater than 90) and poor machining performance without annealing treatment, it can only carry out simple bending (perpendicular to coiling direction) with directivity less than 90 degrees.

Cold rolling steel

In short, cold rolling is produced on the basis of hot rolling. Generally speaking, it is a process of hot rolling → pickling → cold rolling.

The self-made tension simulation four roll cold rolling experimental unit in the rolling center is used for the front and back tension simulation rolling test. The width of roll surface is 400mm, which can be used for the cold rolling test of precision strip and non-ferrous metal. The tension before and after each pass is set by computer screen, and the multi pass rolling is completed automatically.

Self made rolling center of tension simulation four roll cold rolling experimental unit

Equipment performance parameters:

Raw material thickness: 1.5-4.0mm (steel), 4.0-8.0mm (molybdenum); finished product thickness: 0.1-1.0mm, 0.05-0.5mm (molybdenum)

Working roll size: ￠ 175 --- 155 × 430mm;

Support roll size: ￠ 380-350 × 430mm; belt width: 100-350mm; rolling pressure: 3000kN (max); main motor power: dc250kw; rolling speed: 0-0.5m/s

Function and purpose of equipment:

This unit is used for the simulation rolling test of front and rear tension. The width of roll surface is 400mm. It can be used for the cold rolling test of precision strip and non-ferrous metals. The front and rear tension of each pass can be set through the computer screen to automatically complete the multi pass rolling.

Sheet metal forming

The forming performance of sheet metal can be measured and analyzed by the sheet metal forming experimental machine, which can meet the requirements of cup protrusion, drawing, reaming, cone cup, lug, stretch bending rebound, hydraulic bulging test and the determination of forming limit curve.

Hot-rolling

Hot rolling and controlled cooling system

Equipment performance parameters:

Rolling force: 1500KN; rolling torque: 22knm; rolling speed: 0.2 ~ 0.875m/s; billet thickness: 6 ~ 100mm; billet width: 200 ~ 250mm; finished product thickness: 0.8 ~ 30mm; working roll size: ￠ 380 --- 400 × 350mm

Function purpose:

The single stand reversible hot rolling mill with 350mm wide roll surface, replaceable 4-Roll and 2-roll, front and rear roller table, both rough rolling and finish rolling, equipped with holding furnace and controlled cooling device after rolling. The rolling mill mainly carries out heating, rolling and cooling experiments of rolling samples, physical simulation of heating temperature, pass reduction, super fast cooling and online tempering system, analysis and test of the structure and performance of the samples, obtaining reasonable and optimized production process parameters, and providing experimental data for industrial production.